Computer Aided drawing CAD mcq test| Civil engineering test series

This test completely based on Exam pattern and Syllabus, So give this test and Improve your preparations! Wish you very all the best!

Q.1 Which of the following is not a specified method for dimensioning

(A) Parallel dimensioning

(B) perpendicular dimensioning

(C) continuous dimensioning

(D) dimensioning by coordinate

Q.2 For drawing the component of a wrist watch the scale used is

(A) Reducing scale

(B) full scale

(C) enlarging scale

(D) any of these

Q.3 Why should you pay attention to when learning AutoCAD

(A) The command line

(B) the status bar

(C) the title bar

(D) floating toolbar

Q.4 A Polyline can be broken into individual lines and arcs using which of the following command?

(A) BREAK

(B) TRIM

(C) EXPLODE

(D) OVERKILL

Q.5 Guidelines for dimensions at international level on a drawing is controlled by

(A) Bureau of Indian standard

(B) Corporate drafting standard

(C) ANSI

(D) ISO

Q.6 A room of 1728 meter cube volume is shown as 216 centimeter cube volume on a drawing sheet. What is the RF?

(A) 120

(B) 1200

(C) 1250

(D) 186

Q.7 What is a scale ratio of full size scale?

(A) 1:2

(B) 1:3

(C) 1:10

(D) 1:1

Q.8 Long dashed dotted narrow line is used to represent

(A) Line of symmetry

(B) Centre Lines

(C) Pitch Circle of grass and holes

(D) all of the above

Q.9 A status bar does not contain

A) Snap

B) greed

C) erase

D) polar

Q.10 To obtain parallel lines, concentric circles and parallel curves; _________ is used.

A) Array

B) Fillet

C) Copy

D) Offset