Engineering drawing and graphics test for btech 1st and 2nd semester

This test completely based on Exam pattern and Syllabus, So give this test and Improve your preparations! Wish you very all the best!

Q.1 If the distance from the directrix is greater than the distances from the focus then what is the name of the conic section?

(A) hyperbola

(B) parabola

(C) ellipse

(D) circle

Q.2 The ratio of heights to length of an arrow in dimensioning is?

(A) 1:3

(B) 1:2

(C) 1:1

(D) 3:1

Q.3 If a diagonal scale is to be made with a yard, feet and inch then how many divisions it has been made vertically?

(A) 10

(B) 3

(C) 12

(D) 8

Q.4 The TV of a line parallel to the reference line, then is true length is shown in

(A) T.V

(B) F.V

(C) side view

(D) F.V and T.V

Q.5 In third angle projection the.....line between......and........

(A) object, plane of projection, observer

(B) observer, object, plane of projection

(C) plane of projection, observer, object

(D) reference line, side view, front view

Q.6 When a cone is cut by a plane parallel to it's base, and on removing the top portion of the cone, the remaining bottom, top portion is called?

(A) truncated of cone

(B) frustum of a cone

(C) irregular - prism

(D) irregular - cone

Q.7 When the surface of a circle is kept perpendicular to both H.P and V.P the top view and front view of a circle are obtained as......and...... respectively?

(A) circle, straight line

(B) ellipse, straight line

(C) straight line, straight

(D) semi circle, strength line

Q.8 If an metric drawing is made use of isometric scale then the drawing are called?

(A) isometric projection

(B) isometric view

(C) orthographic view

(D) isometric perception

Q.9 How many points do you need to define for the rectangle command?

(A) two

(B) four

(C) one

(D) none

Q.10 Which key can be used to quickly cancel a command?

(A) backspace

(B) esc

(C) tab

(D) enter